When using the vibrating screen, we must first operate according to the operating instructions. Then, the daily maintenance and maintenance of the vibrating screen should also follow the following methods so that the screening effect of the vibrating screen is good and the service life is long.
When using the vibrating screen, we must first operate according to the operating instructions, and then the daily maintenance and maintenance of the vibrating screen should also follow the following methods, so that the screening effect of the vibrating screen is good and the service life is long.
- Before starting the vibrating screen:
(1) The coarse mesh and fine mesh should be checked for damage, and if damaged, it should be replaced in time to ensure the screening effect;
(2) There is also whether each group of bunches is locked - When the vibrating screen starts:
(1) Note that there is no abnormal noise, if there is a noise may be a failure of the equipment, need to stop for inspection.
(2) Whether the current is stable
(3) There is no difference in vibration - After the vibrating screen is used: clean up after each use.
- Check the coarse mesh, fine mesh and spring regularly for fatigue and damage, whether the parts of the fuselage are damaged due to vibration, and the parts that need to add lubricating oil must be lubricated.
1, during the use of drilling fluid vibrating screen, the motor every three months to fill JS-4 high temperature noise reduction lithium base grease once, grease, to prevent foreign bodies into the oil hole, oil injection :30 ~ 40 grams/each bearing.
2, when the amount of oil in the manual oil pump is reduced, the oil pump will not work normally, and 10# oil should be injected in time.
How to use shaker scientifically? What are the daily maintenance and use precautions?
Mud and water separation equipment manufacturers
- When moving and transporting, it is necessary to fix the screen box and place it horizontally to prevent the deformation of the vibrating screen due to severe vibration, thus affecting the service life of the vibrating screen.
4, the thermal relay installed in the electric control box is used as overload and phase loss protection, if the motor and other reasons cause the electric control box trip stop, should wait 5 ~ 10 minutes, and can be opened again after the fault is removed.
5, before use, should start the vibrating screen for about 10 minutes, confirm that there is no abnormal sound and fault, and then turn into the working state. When the vibrating screen is stopped in the middle, it should be washed with clean water in time to avoid the debris and drilling fluid solidifying on the screen and blocking the screen holes. After drilling or stopping use, all parts should be cleaned thoroughly. When cleaning the accumulated chips on the screen, do not use sharp objects, so as not to damage the screen.
6, often check the parts of the fasteners, if found loose should be tightened in time. Check screen fastening bolts in time.
The above is about the operation of the vibrating screen precautions to explain the knowledge, I hope to help you.